Building Black Bedroom Bench
Black Bedroom Bench seats a large number of people cheaply, but they can be placed against the wall when not in use. You can also use them for viewing. Build your own bench that fits into almost any interior and features reinforced seat construction. Wide a layer of glue on the cut end of a 2-by-12-by-15 1/2 inch on board, which will be the bench leg. But this to the bottom of one end of a 2-by-12-by-60-inch board – this will be a bench. Make sure at the end of this bench is also with the outside of the bench leg.
Drive three nails through the seat at the end of the leg. Repeat step one with the other leg on the other end of the bench seat to complete the base Black Bedroom Bench frame. Measure both ends of two 1-by-4-of-61 1/2 inch discs and two 1-of-4-by-13-inch discs. Load one of the 1-by-4-by-13-inch discs so that the slanted corners point upwards. Spread a layer of glue on the flat side and place it against the flat side of the bench leg, so the top edge of 1-times-4 is level with the top of the bench. Run four nails in a rut pattern through 1-times-4 and into the lower leg.
Repeat step four with the other 1-of-4-by-13-inch aboard the other leg. Run a glue string along the length of one side of the bench surface, and on the girder and top of the bench leg at both ends. Place a 1-of-4-of-61 1/2 inch aboard this glued area, with its upper edge aligned with the top of the bench, and attach it with the nails. Drive two nails through 1-by-4 in a bench leg; Repeat with the other leg. Using 21 nails placed about 3 inches apart, nail through 1-by-4 in the bench to make a safe connection. Repeat step six on the other side of the Black Bedroom Bench with another 1-of-4-of-61 1/2 “on board. This will complete the reinforcement for the bench.